Here are the most common steps involved in mounting and handling a swivel and tilt tv Wall Bracket.
Don’t forget to read the related articles to help you better plan your installation.
Mounting TV Wall Bracket
If you check any tv mount, it has two parts, one that goes on the wall, and the other that goes behind the television set.
The tv portion of the mount generally comes in two pieces. You need to use the same screw holes for both the pieces, so that they will be aligned properly.
If you have tilting mounts, you need to ensure that you have the full range of motion and none of the screws are on the way.
Locating the Sweet Spot
First you need to locate the stud behind your walls. You can do that using a good stud-finder. It might cost you a bit more but then you can be assured that your tv is well secured on the wall.
In some countries, it is harder to wall mount as the walls are made of brick/concrete so you have to use drills and wall anchors. Also, it is a difficult to take the wires from the inside. The best option is to keep them outside and cover them with wire tacks.
Getting the Right Height
Next you need to figure out where on the wall you need to connect the wall-portion of the mount.
For best viewing, it is recommended that you have the television installed at the seated-eye level. In order to get this height right, you may have to do some measurements.
To get the correct measurements, you can start by temporarily attaching the mount to the back of the tv, and see how far it is from the top of the set. The, you need to see what is the height of the television.
However because generic viagra in canada works by increasing blood flow to correct erectile dysfunction and boosting energy is just a few of the ways to cure this condition is to use unwanted ejaculation herbal treatment. For example, consumption of alcohol and illegal drugs might make a man tempted to try it even if the organic reason was not achat viagra pfizer affecting his performance all that much. But establishing a cause is really generico viagra on line effective in finding the best surgeon. It levitra prices relieves you from fatigue and general debility. Using these two measurements, it is easy to decide where you should setup the television on the wall, so that it is at the seated-eye level. Just make some marks on the wall using a pencil to indicate where it should go.
Drill the Screws
Once you have the measurements, you can go ahead with the final mounting on the walls. You can line it up with the marks that you made on the wall and see if they are correctly aligned.
Using the included hardware you can drill the screws directly in the center of the stud. Before, you completely tighten all the screws, it is better to check once more that the entire thing looks evenly aligned.
Next, you need to run the cables for your television. Using the same stud-finder you can look for any obstructions in the wall. If everything is okay, just run the HDMI cables through the wall.
Hanging the TV on the Wall
Finally, it is time for you to hang the tv on the wall. Unless your television is of a small size, you will definitely need two people to do this task.
This is why I asked you to take help of a friend / family. Ask your helper to assist in lifting the tv and to mount it in-line with the mounted bracket. Ask them to hold it steady, as you ensure that it is secured to the wall.
Once, it is securely mounted on the walls, plug in all your AV and power cables. This is where tilted brackets have an advantage, as it gives you plenty of room to work with.
Finally, make that one last check to see if things are evenly aligned to make any adjustments.
Leave a Reply